Huracan triple stage horizontal pump
Designed to power filter presses; it can be supplied with single or two speed motors, with pump-motor coupling via belts and pulleys or with direct coupling via a coaxial coupling.
Depending on the version, a range of flow rates is available, from 100 lt/min to 10,000 lt/min with internal pressures up to 16 bar.
The bodies and wheels can be made of superalloys or spheroidal cast iron coated with special anti-abrasive rubber compounds.
The suction port is positioned so that the sludge does not come into direct contact with the mechanical seals, which are made of tungsten carbide, drained with water and protected by a pressurized barrier chamber.
The operation of the bearings is guaranteed by oil bath lubrication.
technical specifications
AXLE
Horizontal pump shaft with sealed chamber bearings sized to allow the front of the shaft to cantilever without supports immersed in the liquid.
COUPLING
By means of belts and V-belt pulleys with protective casing.
BODY
Made of cast iron, divided into two halves with a protective coating of our special wear-resistant molded compound, consisting of replaceable shells adjustable from the outside, allowing both quick and convenient replacement and eliminating any play due to normal wear. With axial suction port and upward facing discharge port.
IMPELLER
Anti-clogging, made of abrasion-resistant superalloy.
SEALING UNIT
Composed of a double flushed seal.
BASE
Steel frame to support the pump on the ground.
Brochure
Brochure pompe horizontale à triple étage Huracan
Votre courriel / Your email :